User's Manual

Test the keypad. To ensure the IBR-ITAB is connected with

the correct ISEE-WAP, press the Back/Power Button re-

peatedly until the Home Screen appears, then press the Se-

curity button. A screen with your arming choices appears:

Arm the system by first pressing AWAY, then press the User

Code in the keypad that appears. Ensure the keypad text on

the IBR-ITAB matches the keypad text that appears on the

standard wired keypad.

In the Home Screen, when connected, a con-

nection strength indicator appears at the top

right (1-4 bars, as shown). If you wish to verify

the connection, press this icon and text ap-

pears at the bottom of the IBR-ITAB screen

confirming the validity of the connection. For

example, the text may read:

"Connected with ssid: WAP345, Level: Excellent, IP:

192.168.50.102, Port: 8003, Gateway: 192.168.50.2"

Signal Strength

Indicator

At this point you have successfully installed, configured and locked down the iBridge system. Additional manuals are

included with this system as follows:

Z-WAVE PROGRAMMING AND USER GUIDE (OI378)

If your customer plans to use Z-WAVE devices, then consult OI378, "Using your iBridge IBR-ITAB Series Home

Automation System". This user guide describes how to enroll and control Z-Wave devices. As a Dealer, you have

the choice to either allow or disable access to Z-WAVE configuration

menus by the end user. This setting is

discussed in the following WI1944.

CONFIGURING THE IBR-ITAB (WI1944)

The IBR-ITAB Installation, Mounting and Programming instructions describes how to physically install the IBR-ITAB

to the wall and also describes the three (3) types of menus in the IBR-ITAB. They are:

1. User Settings: User Settings are options that your customer can set to control the IBR-ITAB. Tap the System

Settings "gear" icon once (lower left corner of the Home screen) to access this menu. Descriptions of each

feature are described in the IBR-ITAB Security System User Guide OI372.

2. Dealer Settings: Dealer Settings are options that the Dealer configures. These menus are accessed via the

same "gear" icon but by pressing and holding the "gear" icon for 3 seconds (a password is required to access

these menus).

3. Android Settings: Within Dealer Settings there is an option to access the Android menu system. The Android

menus should not be accessed by the Dealer; these menus exist for troubleshooting purposes when in contact

with our Technical Support department.

IBR-ITAB SECURITY SYSTEM USER GUIDE (OI372)

This user guide describes how to use the security keypad on the IBR-ITAB screen, and perform tasks such as

arming Stay (protecting yourself at home), arming Away (setting the alarm when leaving), arming Night (protecting

yourself when sleeping), bypassing zones, and all other aspects of the customer's security alarm system.