User's Manual

Configure the Wireless Cameras. Be sure all wireless

cameras are powered, then tap (3) Configure Wireless

Camera.

A confirmation popup appears; tap Yes to proceed (or tap

No to exit without saving changes).

Wait while the IBR-ITAB searches for all cameras. When

finished searching, the IBR-ITAB lists all the discovered

cameras by IP address. Tap to select each camera one at a

time and tap "Lock" to lock the camera. Exit when com-

plete.

Lock Down the ISEE-WAP.

In the Connection Settings menu, tap (4) Lock Down

IBRIDGE ISEE-WAP.

Locking the ISEE-WAP turns off the default "PUBLIC" SSID

so no other systems can connect to your equipment. Any

new IBR-ITABs will have to use the new SSID and Key en-

tered in the Preferred Network dialog above.

In the Information popup that appears, tap Continue.

Wait several seconds until the following popup appears:

Tap OK to close.