User's Manual

21
Universal Operation
Wiring for Garage Door Control
In Universal operation, the 2WAY-UNIVKF may be used to
control a garage door opener, or any other access control
device which requires a momentary closure for activation.
The typical installation will require that the N/O and COM
terminals of Relay 3 be wired across the wall mounted push-
button switch for the garage door control as shown in the
diagram below.
•
Pressing the
∗
button will provide a 2 second short
across these terminals, prompting the garage door
opener to activate.
Garage door opener wall mounted
push-button switch, or normally open
garage door opener input.
Typical wiring for a controlling a
garage door opener from KeyFob.
COM
14
N/O
N/C
15 16
GARAGE DOOR CONTROL
Note:
There is no need to re-enroll the KeyFobs after
a battery change.
Always use only AAA 1.5 Volt alkaline batteries.
3
Replace battery compartment cover
Changing the KeyFob battery
!
1
Open battery compartment on back of Keyfob.
AAA
+
2
Remove old battery and replace with new.
2WAY-UNIVKF_WI1024J.19_I...
page 21
Friday, February 13, 2004 08:57
Composite