QUICK START GUIDE The full user manual can be found online at: Sightmark.
PACKAGE CONTENTS: - IR Illuminator USB Cable Objective lens cover Quick Start Guide CHARGING THE WRAITH 4K MAX: The Wraith 4k Max comes with a built-in rechargeable battery. To charge it: Open the charging cover (1), plug the USB cable into the USB Port of the Wraith 4k Max and attach the other end to a USB power supply. 1 BASIC OPERATION: To turn on the Wraith 4K Max hold the power button (2) until the screen turns on.
DIAGRAM 5 4 1. Charging Cover 2. Power Button 3. Focus Adjustment 4. Eyepiece 5. Adjustment Knob 3 2 1 MOUNTING AND ZEROING: TO MOUNT THE WRAITH 4K MAX: 1. Loosen both mount thumbscrews. 2. Place mount on to Picatinny rail aligning the bolts with the Picatinny rail slots. Check eye relief and adjust to the proper position. 3. Tighten thumbscrews to 20-25-inch pounds. TO ZERO THE WRAITH 4K MAX: 1. 2. Take 1-3 shots at a target at the range you would like the scope to be zeroed at.
USING THE IR ILLUMINATOR: There are 3 ways to adjust the IR Illuminator: 1. To turn the IR on adjust the brightness twist the dial (1) on the back of the battery cap to the needed brightness level. 2. To focus the beam of the IR Illuminator twist the IR focus adjustment (2) 3. To adjust the angle of the IR Illuminator loosen the screw (3) on the mount and adjust the angle until it is aligned with the center of the image through the scope at the range you want and then tighten the screws to hold it in place.
FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
