Specifications

Addi onal fans in the side panel:
If you want to accommodate a fan in the side panel, remove the outer cover by loosening the
screws on the inside.
The dust  lter can remain in its posi on.
Please place the fan on the inside of the side
panel above the dust  lter and screw it in
from the outside.
If you secure the cover in the side panel again a er the removal of a side fan, please make
sure not to  ghten the screws not too much. To avoid damage to the internal thread or the
side panel, the screws should be  ghtened by hand only.
Addi onal fans at the case bo om:
If you want to install an addi onal 120 or 140 mm fan on the bo om of the case, remove the
hard drive cage holding  xture located at the bo om. The HDD cage is fastened with four
screws from the underneath of the case.
13