Specifications

9. Installing a water cooling solu on

In the Nanoxia Deep Silence 6, you can install both in the specially designed moun ng bracket,

as well as under the cover radiators or compact water cooling solu ons.

9.1 Installa on of a radiator or compact water cooling solu on on the moun ng bracket

behind the HDD-cage

The Nanoxia Deep Silence 6 is equipped with a special moun ng bracket that is ideally

prepared to receive a 120/140/240/280 mm radiator. It makes it possible to mount a radiator

and can be equipped with up to four fans for maximum heat-dissipa on. Including the pre-

assembled 2 x 140 mm Nanoxia Deep Silence fans behind the front panel, up to 6 fans provide

a superior cooling performance.

In order to  x a radiator on the Moun ng Bracket, you need to remove it  rst by removing the

four screws, with which the holder is a ached to the HDD cage (see chapter 6.3).

Next, set the radiator you would like to install  at on the table. Posi on the moun ng bracket

with the outside on the radiator as seen in the picture below.

Put up to two 120 or 140 mm fans into the Moun ng Bracket and connect fans, bracket and

radiator with extra-long screws.

For maximum cooling capacity of your radiator, you can then mount up to two addi onal 140

mm or 120 mm fans on top of the radiator.

If you use a very large radiator, it may be that the hose connectors block the moun ng

screws of the frame. In this case, please use the special, included thumbscrews to  x the

frame to the case.

Radiator

with 2 fans

mounted

Radiator

with 4 fans

mounted