Specifications
When you remove the top cover, proceed
cauously in order to not damage the
cables of the I/O-Panel and the Acve Air
Chimney. To remove the cover completely,
you need to remove the right side panel
and disconnect the cable to the board that
goes to the switch of the Acve Air
Chimney (see drawing).
FAN3 FAN2 FAN1
POWER
SWITCH
6. Fan assembly
Five 140 mm fans are pre-installed in your Deep Silence 6. You can mount up to twelve fans in
total.
We recommend the use of the 120 or 140 mm Nanoxia Deep Silence fans, available separately.
These are technically and visually equivalent to the factory-installed case fans and will work in
perfect harmony with the built-in fan control of your case.
You can, of course, connect the addional fans to the fan controller (see Chapter 7) or, where
applicable, to the Acve Air Chimney (see chapter 8).
All air intake openings of the Deep Silence 6 are equipped with easy to clean dust lters. We
recommend that you clean them on a regular basis.
6.1 Fans in the front
To switch the fans in the front or to clean
the dust lters, rst open the lower front
door. Next, open the “Easy Access Panel” by
pushing slightly on the le side of the panel
(picture 6A).
picture 6A
12