Specifications

3.1 Mounng of hard disk drives

Install the 2.5 or 3.5 inch hard drives in the illustrated mounng frames. In order to extract the

frame, squeeze the protruding brackets and pull the slide out gently.

To install a hard drive into a bracket insert the disk so that the connectors point to the back and

aach the hard drive using the screws provided

For the ng of 3.5 inch hard drives

please use the holes in Figure 3A

For the ng of 2.5 inch hard drives

please use the holes in Figure 3B

To lock the drive, push the bracket with the

drive back installed back into the slot unl the

bracket is re-engaged.

3.2 Conversion and removal of the HDD-cages

Your new case is equipped with three modular HDD-cages (2 x 3-bay, 1 x 5-bay). The cages can

be removed, swapped or reposioned.

Due to this unique variability, you can:

- Adjust the number of available HDD mounts

- Install extra-long graphic cards

- Opmize the air ow within the case

- Mount a water cooling system behind the front fans

To remove the upper HDD cage, rst remove the le

side as seen from the front as well as the two thumb

screws that secure the cage. Then you can carefully

pull it out.

Figure 3A Figure 3B