Specifications

2. Installaon of external drives

You can install up to four external drives. An adapter frame for mounng a 3.5 inch drive is

included.

2.1 Opcal drives

To install the opcal drives, please remove both side panels. The installaon of opcal

drives is tool-free.

Remove the 5.25 inch cover by pulling the

lateral lng lever cauously towards you

and take out the cover.

Then loosen the lock on both sides by drag-

ging the black slider backwards (1).

Then slide the drive into the desired posi-

on.

Lock the holder by pushing the slider back

to its original posion (2).

2.2 Ulizing the external 3.5 inch bay

If you for example desire to place a 3.5 inch card reader, you can use the internal adapter for

this purpose. Please remove at rst the 5.25 inch cover (see chapter 2.1).

Open the two quick release of the boom 5.25 inch bay and remove the adapter frame. Install

the card reader in the frame and then put both the frame and the card reader back into the

bay. Lock the quick-release. At the end you can put the included 3.5 inch adapter plate carefully

before the card reader.

3. Installaon opons of HDD’s

The Deep Silence 5 Rev. B allows you the decoupled mounng of 14 hard disk drives. A total

of 11 x 2.5/3.5 inch bays are available. Included is the newly developed 6 x 2.5 inch mounng

frame, which will take three 3.5 inch bays for installaon. By using the 5.25 inch to 3.5 adaptor,

you can mount a total of 15 hard disks drives in your case.