Specifications
EN
5.2 Fans under the top cover
If you want to install addional fans at the top of the case, please remove the Nanoxia VentCovers
rst by removing the screws on the outside of the case.
Next, hold the fans from the inside and secure them to the top by fastening the screws from
the outside.
Case fans installed at the top of the case should exhaust air out of the case (fan rear side
facing outwards).
5.3 Fan at the boom of the case
You can install a 120 or 140 mm fan on the boom of the case. To do that, you must remove
the secondary HDD-cage mounng rail from the case boom. We recommend the following
procedure:
a) Remove the dust lter and unscrew the
screws on the two guide rails of the lter to
remove it.
b) To remove the secondary hard drive
bracket, please remove the four screws, as
shown on the image.
c) Please place the fan on the inside of the case and secure it from the outside
d) Aach the dust lter mounts again to the case boom and slide the dust lter back to its
original posion.
12