Specifications

3.3 Conversion and removal of the HDD-cages
Your new case is equipped with three modular HDD-cages (2 x 3-bay, 1 x 5-bay). The cages can
be removed, swapped or reposioned.
Due to this unique variability, you can:
- Adjust the number of available HDD mounts
- Install extra-long graphic cards
- Opmize the air ow within the case
- Mount a water cooling system behind the front
fans
To remove the upper HDD cage, rst remove the
le side panel as seen from the front as well as
the two thumb screws that secure the cage. Then
you can carefully pull it out.
If you want to remove the lower hard drive cage in order to install a water cooling radiator,
simply loosen the 8 screws holding the cage to the chassis.
First remove the front panel (see chapter 4.1).
Next loosen the four screws securing the HDD cage to the front panel.
Finally, remove the four screws at the boom of the case which allow the cage to be removed.
09