Full Product Manual

7
Product Setup
Nanoleaf Essentials - User Manual
The lightstrips should only be installed indoors and
on a flat surface. Clean your surface to be free of
dust and moisture. Tape is NOT recommended for
textured, porous, popcorn and ceiling surfaces (ie.
wallpaper or brick walls).
Attach your lightstrip to the Controller, and the Controller to the PSU (3.1). Peel the tape back and firmly stick it
onto your desired surface (3.2). Press firmly along the length of the strip to ensure a strong adhesion (3.3). Plug
the strip into the power and you’re ready to pair! For full pairing instructions, skip to page.8.
Prepare Your Surface
Attach Your Lightstrip
2
3
3.2
3.1
3.3
If your lightstrip needs to be shortened,
make sure the male end of the strip is
already connected to the Controller (3.1).
Once connected, cut your strip from the
other end (female side). Make sure to do
so along the indicated cut line to avoid
damaging your strip.
Cutting a Lightstrip?
NOTE: Once cut, the strip cannot
be connected back together, so
ensure you’ve measured properly
before cutting.