Full Product Manual

WARNINGS &
CAUTIONS
Nanoleaf Aurora is not designed for use in:
▪ Enclosed locations that limit the ow of air and/or trap excessive amounts of heat
▪ Emergency exits or emergency lights
▪ Conjunction with 3rd party sensors/timing devices that are not approved by Nanoleaf®
▪ Places where there is a risk of electric shock
▪ Outdoor areas
▪ Wet or damp conditions
▪ Excessively hot environments (e.g. close to ovens, radiators, heaters, etc.)
▪ Regions or countries other than that in which the product was intended for.
When using Nanoleaf Aurora:
▪ Do not open the device, as this will void the warranty.
▪ Do not place any metallic or conductive objects near the exposed contacts on the
Aurora controller, power supply, linkers, or back of the Aurora panels.
▪ Do not allow small children to operate this device unsupervised. This device contains
small parts that may be a choking hazard to small children.
▪ Do not clean the device when it is on and or connected to power.
▪ Clean the panels with a soft dry cloth, do not use cleaning agents.
▪ Do not bend the panels with the linker still attached.
▪ Do not attach the panels together with anything other than its original panel linkers.
▪ Do not puncture the panels with any nails or screws during installation.
▪ Do not attach the panels to a ceiling without extra adhesives to secure the panels
from falling.
▪ Do not attach the panels to the oor where it may get stepped on.
▪ Do not place the panels in water, or expose the panels to water.
▪ Do not use mounting tape for the following surfaces: Unpainted brick wall, wall paper,
uneven/bumpy surfaces,
Please read this safety information carefully and keep this user manual for later reference.