User's Manual

ZDC ZA-5000-D User's Manual V2.3.2
Chapter 4 Advanced Configuration
Page 32
The remote Bridges will not be able to communicate with each other if this feature is
enabled.
Figure 23 Wireless Separator
Outdoor Point to Multi-Point Bridge Application
In some application structure, there is a wireless bridge as centre point, other bridge access
network by connecting it. We can this structure “Point to Multi-Point Bridge” just like “Point to
Point Bridge”, we also suggest you should make all wireless bridge build a network and make sure
than each bridge work well indoor, then take them outdoor for use. The following should be
noticed:
z The settings of centre point:
Set it as “Wireless Point-to-Multi-Point Bridge” mode, add all remote bridges MAC address
in the remote MAC address textbox.
z The settings of remote point:
Set it as “Wireless Point-to-Point Bridge” mode, add centre bridge MAC address in the
remote MAC address textbox; because all the remote points share the throughput of centre
point, the throughput between two remote points is half of that of one remote with centre
point.
z Link Test of multi points
In centre point, input the real space between centre point and the furthest remote point in
Space between Bridge textbox. In each remote point, input the real space between centre
point and it in Space between Bridge textbox.
In the Link Test page of centre point, you can test signal strengthen of each remote point.
z Down Flow Band Control
You can control the throughput between centre and remote by set the value (Mbps) in the