User's Manual

ZDC ZA-5000-D User's Manual V2.3.2
Chapter 3 Basic configuration
Page 19
Notice:
8 2447
9 2452
10 2457
11 2462
12 2467
13 2472
14 2484
z Data Rate
The available transmit data rate of the wireless network. The AP will choose the highest data
rate to transmit data in Best mode. You also can choose lower data rate in order to transmit
data in longer distance.
z Output Power
Adjust the transmit power of the Access Point. The more the Output Power the more area of
the wireless signal can reach. Its default value is Full.
z RTS Threshold
Request to Send Threshold. Its value is from 0 to 2346 bytes, RTS is designed to solve
Network collision. It will make signals lose if two stations send data to AP at the same time.
When the transmitted data size is larger than RTS threshold, the RTS mechanism will be
active. The transmitting station sends out an RTS packet to the receiving station, and waits
for the receiving station to send back a CTS (Clear to Send) packet before sending the actual
packet data. The other station which have listen the CTS will waits for a time before send
data. The default value is 2346 and not active. If set it to zero, this function will be active
always.
z Fragmentation Threshold
This is the maximum packet size used for fragmentation and can only be set as even number.
Packets larger than the size programmed in this field will be fragmented. The little packet
data can reduce loses and raises the quality of transmission.
The Fragment Threshold value should be larger than the RTS Threshold value or the RTS
Threshold is zero, otherwise the RTS function will not work.
Fixed power level.