User's Guide
Table Of Contents
- Workplace health and safety工作场所健康与安全
- Electric Safety 电气安全
- Safety of Machinery 机械安全
- Burn Risk烧伤风险
- Safe Storage安全储存
- About "Wiibox Linght" 有关“Wiibox Linght”
- How does it work?如何运作？
- 产品规格Product Standard
- 建议环境
- Suggestion environment
- 包装清单Pack list
- 主要部件Main part
- 3D打印技术词汇 3D Printing Technology Term
- 首次使用准备工作Preparation Work for First Use
- 切片支撑软件“wiibooxslicer”使用
- Use of Slice Support Software "wiibooxslicer"
- 启动打印 Start Printing
- 后处理Post—process
- 关于打印失败的处理Treatment of Print Failures
- 更换材料Change the material
- 可用材料Available Materials
- 基本维护和服务工作Basic Maintenance and Service Work
- 支持和故障排除Support and Troubleshooting
- 回收Recovery
WIIBOOX LIGHT-3D Printer User Guide
WIIBOOX LIGHT-3D
打印机用户指南
Page 7 of 16
4. 插入电源线并开启打印机。
4 .Insert the power cord and turn on the printer.
5.进入主菜单界面，将 Z 轴抬升 50mm(如下图顺序）
5. Enter the main menu interface,lift the Z axis by 50mm ( As shown in below).
6.检测设备曝光情况
6.Test equipment exposure
曝光 曝光正常
Exposure Normal exposure
7. 检测平台的对准
7.Check the platform alignment
a.取下材料盘,逆时针拧松料盘固定螺丝，将料盘和螺丝同时取出。
a. Take out the material plate and unscrew the fixed screw counterclockwise in the material plate. Take out the material
plate and the screw at the same time.
b.在 LCD 成型模块上放置打印机附带的测试纸（如下图放置）
b. Place the test paper attached to the printer on the LCD molding module (as shown below)
c.将平台回“0”，压住纸条并进行拉动测试（如不正常再请观看随机附带的调节视频）
c. Return the platform to "0", hold down the strip and carry out the pull test (if abnormal, please watch the random
accompanying adjustment video)
回“0” 无法拉出纸条（或感觉纸条摩擦）则正常
Back “0” Failure to pull the strip (or to feel the strip rub) is normal