User's Guide

WIIBOOX LIGHT-3D Printer User Guide
WIIBOOX LIGHT-3D
打印机用户指南
Page 13 of 16
4. 将取下的模型放入酒精清洗盒(自备），浸泡约 3-5 分钟(不可超过 10 分钟），然后轻轻晃动模型清洗掉模型表
面粘附的树脂。
4. Put the removed model into the alcohol cleaning box, soak for about 3-5 minutes (not more than 10 minutes), then
gently shake the model to clean the resin adhering to the surface of the model.
5.去除支撑，从模型边缘破坏支撑结构后撕下全部支撑，必须佩戴防护手套，注意防止模型尖锐部分划伤。
5. Remove the support and all supports were torn off after the support structure was destroyed from the edge of the model.
Protective gloves must be worn. Be careful to prevent sharp scratches on the model.
6.将模型放入 UV 二次固化机或任何紫外线源下（例如直射阳光）。
*根据您用于打印的树脂类型选择二次固化时间，此步骤是可选的。
6.Place the model in a UV secondary curing machine or any ultraviolet source (such as direct sunlight).
* Select the secondary curing time according to the type of resin you use for printing. This step is optional.
7. 对模型表面进行简单打磨处理，您可以使用锉刀、粗细砂纸等工具配合打磨，以达到较好的表面效果，必须佩戴
手套防止对树脂有过敏反应
7. Carry out the simple polishing on the surface of the model. 8. You can use tools such as file and sandpaper to polish in
order to achieve better surface effect. Gloves must be worn to prevent allergic reaction to resin.
8.将平台完全清理干净，无任何固化物或其他杂质后安装到打印机，并关闭防尘遮光盖
*材料在 7 日内不使用的情况下不用回收，超过 7 日应该将材料回收到相应的材料瓶内储存，以免长时间暴露在空
气中变质.
*打印机以及材料都不能放置在阳光照射的位置或窗口，阳光中包含的大量紫外线会使材料固化报废。
*不能放置在射灯或其他强光 led 灯下。
8. Clean up the platform completely, install it to the printer without any solidification or other impurities, and close the
dustproof shading shield.
* Material shall not be recycled if it is not used within 7 days. Material should be recycled to store in corresponding