User's Guide
Table Of Contents
- Workplace health and safety工作场所健康与安全
- Electric Safety 电气安全
- Safety of Machinery 机械安全
- Burn Risk烧伤风险
- Safe Storage安全储存
- About "Wiibox Linght" 有关“Wiibox Linght”
- How does it work?如何运作？
- 产品规格Product Standard
- 建议环境
- Suggestion environment
- 包装清单Pack list
- 主要部件Main part
- 3D打印技术词汇 3D Printing Technology Term
- 首次使用准备工作Preparation Work for First Use
- 切片支撑软件“wiibooxslicer”使用
- Use of Slice Support Software "wiibooxslicer"
- 启动打印 Start Printing
- 后处理Post—process
- 关于打印失败的处理Treatment of Print Failures
- 更换材料Change the material
- 可用材料Available Materials
- 基本维护和服务工作Basic Maintenance and Service Work
- 支持和故障排除Support and Troubleshooting
- 回收Recovery
WIIBOOX LIGHT-3D Printer User Guide
WIIBOOX LIGHT-3D
打印机用户指南
Page 12 of 16
c.选择打印文件 d.确认打印
c. Select the print file d. Confirm print
e.等待开始曝光后即可拔出 U 盘
e. Wait for the exposure to start, then you can pull out the USB flash drive.
4.通过打印机屏幕显示界面信息可以预算打印完成时间。
4.Printing completion time can be estimate by displaying interface information on the printer screen.
后处理 Post—process
1. 完成打印过程后，请等待模型表面树脂大部分从模型中排出。
1. After finishing the printing process, please wait for most of the resin on the surface of the model to be discharged from
the model.
*根据模型的大小和几何形状，您可以对平进行转动让树脂更多的流入材料盘内，以节省液态树脂。
* According to the size and geometry of the model, you can rotate horizontally so that more resin flows into the material
plate to save liquid resin.
2. 带上防护手套，拧松平台固定螺钉（约拧动两圈）。取下平台,小心不要将液体树脂洒在打印机及其周围。
2. Wear protective gloves and unscrew the platform fixing screw (about two turns).Take out Platform and be careful not to
spray liquid resin around the printer.
3. 带上防护手套，使用美工刀或其他比较薄的工具，将模型沿边缘取下，必须注意安全。
3. Wear protective gloves and use a utility knife or other thinner tool to remove the model along the edge. Care must be
taken.