User's Manual
Table Of Contents
- Software specifications
- Software features
- Software functions
- 1.Introduction to “Register” and “Sign in” functions
- 2.Introduction to “Measuring ” function
- 3.Introduction to a real-time ECG waveform diagram
- 3.Introduction to “End Measurement” function
- 4.Introduction to “Data Uploading” function
- 5.Introduction to “Measurement Records” function
- 6.Introduction to “User Profile” function
- 7.Introduction of “Playback ECG” function
- 8.Introduction of online customer service function
- 9.Set Sign-in password
11
Warning: the device should be attached on your left chest with the side
marked with red dot pointing up at a 45 degrees angle towards your right
shoulder, as shown in illustration b above.
3.3.3 Starting measurements
Method 1（recommended）：Use the smartphone app to start the measurements.
Ensure the device has sufficient power, indicated by a steady green light. Start
the app, turn on Bluetooth as instructed, connect to the device. Once the
connection is successful, the “Start measurements” button will appear, tap to
start. The green light on device will blink once every 5 seconds to indicate
measurements in progress.
Method 2: Use the button on device to start the measurements. Long press the
button on device for at least 4 seconds until the green light starts to flash,
the device will start a new measurements session, the green light will blink
once every 5 seconds to indicate measurements in progress.
Warning:
1. Using the device to start measurements may overwrite previous measurement results,
so the recommended way to start measurements is from the smartphone app.
2. When using, storing device, be careful to protect from moisture and avoid liquid or
foreign material entering the device to damage internal electronics, causing failure.
3.3.4 View Real-time ECG Waveform
Real-time ECG can be viewed inside the app. Start the app, turn on Bluetooth as
instructed, connect to the device. Once the connection is successful, you will land on the
measurements page, tap on the “Real-Time ECG” button to start viewing real-time ECG for
up to 30 seconds.
Warning: External factors such as strenuous exercises may affect the accuracy of the
measurements.
3.3.5 View measurement results
You can use the app to view measurement results. Start the app and go to the data
upload page, tap the “View Results” button to view measurement results. Tap the “Records”
menu to see historical measurement results.
3.3.6 Stop Measurements
The device is capable of continuous measurements for up to 24 hours. Use the “Stop
measurements” button on the measurements page to stop measurements. The green light on the
device will return to the steady state, the device needs to keep connecting with smartphone
through Bluetooth to upload measurement data to the cloud for safe storage.
3.3.7 Data Upload
Measurement data collected by the device will be sent via the app to store in our cloud
storage for up to 3 years. The app is capable of sending data to the cloud during
measurement sessions, once measurement is complete (steady green light), the device should
be connected to the app via Bluetooth for some time, in order to complete the data upload
from the device to the cloud. Once the upload completes, you can examine the new
measurement results in the app or start a new measurement.
3.3.8 Device restart
To restart a new measurement, Please press and hold the button on the device
for 4 seconds till the green light starts to blink. This can be used to
effectively start a new measurement session when your smartphone is not near the
device.