User's Manual
Table Of Contents
- Software specifications
- Software features
- Software functions
- 1.Introduction to “Register” and “Sign in” functions
- 2.Introduction to “Measuring ” function
- 3.Introduction to a real-time ECG waveform diagram
- 3.Introduction to “End Measurement” function
- 4.Introduction to “Data Uploading” function
- 5.Introduction to “Measurement Records” function
- 6.Introduction to “User Profile” function
- 7.Introduction of “Playback ECG” function
- 8.Introduction of online customer service function
- 9.Set Sign-in password
10
Icon 7
ECG Results
History
Tap the icon to access ECG results history.
3.3 How to use the Swcan ECG Monitor
3.3.1 Battery installation
Please rotate and open the back cover (a coin can be used in the slot to assist), place
a new CR2032 battery inside the battery compartment with the positive (+) side up, then
replace the cover and rotate to tighten. A steady green light indicates the device is ready.
Warning: Poor quality batteries or batteries with insufficient charge may result in
device startup failures.
3.3.2 Attach the single-use disposable ECG electrodes
1）Connect the device to the single-use disposable ECG electrodes as shown in
illustration a below:
（a）
2）Clean skin area with warm water where the electrodes would be attached, wait till
dry. Place the device as shown in illustration b below and gently press the electrodes
on to the skin. Apply light pressure to ensure good contact between the electrodes and
the skin for best conductivity.
（b）