Safety Information

SRT Caller

Name: specify a name for current task to facilitate server management,

which will be displayed in server list.

■

Stream: choose to stream main or sub stream, which can be customized in

Encoding Parameters tab.

■

Address: enter the Listener address when Mode is set to Caller. If the SRT

listener and caller are on the same LAN, enter the private IP address of the

SRT listener on the LAN. If the SRT listener and caller are in different network

environments, enter the public IP address of the SRT listener.

■

Port: enter the port number specified by the encoder, which ranges from 1

to 65535.

■

Latency: possible values are 30, 60, 120, 500, 1000, 5000, 8000ms. The

default value is 120. We recommend that you set the same latency for SRT

caller and listener.

■

Bandwidth: indicate the portion of the total bandwidth of a stream required

for the exchange of SRT control and recovery packets. Available values are

10%, 25%, 50%, 75%. A worse network condition requires more bandwidth

for overhead to ensure normal transmission.

■

Stream ID: specify Stream ID of 0 to 256 characters which should be

consistent with that of its sender.

■

Encryption: specify the stream encryption algorithm to ensure the data

security, options are AES-128/192/256.

■

Passphrase: specify stream key of 10 to 79 characters, which is the same as

the SRT listener.

■

Test: check the connection between the server and encoder.

■