User's Manual

131
To configure DHCP via Phone interface:
1. Press Menu→ Settings→ Advanced Setting (password: admin)→ Network→ WAN Port→ IPv4→
DHCP mode.
2. Click Save and the pop-up box shows "System will reboot, Are you sure?"..
To configure a static IP address via Phone interface:
1. Press Menu→ Settings→ Advanced Setting (password: admin)→ Network→ WAN Port→ IPv4→
Static mode.
2. Enter the parameters: IP, Netmask, Gateway, Pri.DNS(primary DNS), Sec.DNS (second DNS) in the
corresponding fields.
3. Click Save and the pop-up box shows "System will reboot, Are you sure?".
4. Press the OK soft key to accept the change or the Cancel soft key to cancel. If you are using an xDSL
modem, you can connect your phone to the Internet via PPPoE mode. You can set a WAN port to be a
PPPoE port. The PPPoE port will perform a PPP negotiation to obtain the IP address. Contact your
system administrator for the PPPoE user name and password.
To configure Network via Web interface:
1. Click Network→ Basic→ IPv4 Setting
2. Select the desired Type: DHCP, Static IP Address or PPPoE
3. Fill in the necessary information.
4. Click and the pop-up box shows "System will reboot, Are you sure?"..