Installation Guide

Make sure your subfloor is flat, level, and free

from any dust or debris.

After you have glued down the artificial turf,

use a weighted roller to roll the newly turfed

area. This added step will help insure that your

new artificial turf installation is properly glued

down and adhered to the subfloor.

The last step (OPTIONAL) is to add the turf fill.

a. Use a large brush broom to make the turf

blades stand up.

b. Apply the turf fill, using a drop spreader,

to the brushed turf area.

c. Make sure to spread the fill evenly as possible

across the brushed turf area.

d. Once the fill has been spread evenly, brush

it in lightly to create a finished look.

e. The artificial turf grass blades should be

standing straight up with turf fill underneath.

Next measure your area and map out where

the artificial turf will be installed.

Glue down underlayment or padding to

increase the longevity of your new indoor turf area.

Once your underlayment or padding is installed

you will then glue down your artificial turf grass.

Allow for ample time (15-30 minutes) for the

adhesive to air dry before laying the artificial turf

Take your time and move slowly when making cuts

(only from the back) during the installation process,

make sure to keep the turf blades going in the same

direction when installing.

INDOOR INSTALLATION

PAGE 1
INDOOR INSTALLATION 7 Make sure your subfloor is flat, level, and free from any dust or debris. Next measure your area and map out where the artificial turf will be installed. After you have glued down the artificial turf, use a weighted roller to roll the newly turfed area. This added step will help insure that your new artificial turf installation is properly glued down and adhered to the subfloor. 8 The last step (OPTIONAL) is to add the turf fill.
PAGE 2
OUTDOOR INSTALLATION 6 Make sure your area is flat and has been graded to level. Next measure your area and map out where the artificial turf will be installed. Once you have a proper substrate (concrete, rock bed, or sand) you are ready for installation. Add the turf fill. a. Use a large brush broom to make the turf blades stand up. b. Apply the turf fill, using a drop spreader, to the brushed turf area. c. Make sure to spread the fill evenly as possible across the brushed turf area. d.