Installation Guide

P: [phone]
F: [phone]
Installation of a semi-recessed sink is very similar to the installation of
a vessel or supported sink. Upon receiving the sink, you must cut the
proper measurements out of where you will be mounting the sink (i.e.
vanity or table top). Once the top is cut to fit the sink and the piping
is in place, you can mount the sink onto the table top. Line the bottom
of the sink with silicon. Press the sink firmly into the vanity and remove
any excess silicon with a rag. Connect the corresponding piping for
the sink.
Semi-Recessed Wash Basins
After the plumbing and pipes are set into place with the vanity,
connect the sink to the corresponding pipes through the vanity. To set
the sink in place, line the bottom rim with silicon. Press the sink firmly
into the vanity to ensure the permanent placement of the basin and
remove any excess silicon with a rag. Connect the corresponding
piping for the sink.
Supported or Vessel Wash Basins
The mounting hardware included with the sink is 4 double angle
brackets, 4 screws and washers, and 4 nuts and 10 mm bolts. Once
you have the vanity and countertop ready for the sink, position the
under mount kitchen sink and counter top and mark the position of
holes to be drilled from below. The angle bracket will sit underneath
the lip of the sink. The longer side of the bracket will be aligned with
the underneath of the countertop and the screws and washers will be
drilled in at an angle. The shorter side of the bracket will fit the nut
and bolt and the sink lip will sit on top of that. There is one bracket set
for each side of the sink.
Under mount or Recessed Wash Basins