O W N E R S M A N U A L Tuners
page 1 2 3 4 5 8 10 12 1.0 Equipment installation 1.0 Equipment Installation 1.1 cables and connections 2.0 Getting Started 2.1 switching on and off 2.2 running in 2.3 mains supply 2.4 siting the equipment 2.5 if you have a problem 3.0 Warnings 4.0 Connection 4.1 mains lead 4.2 non-rewireable mains plugs 4.3 fuse carrier 4.
2.0 Getting Started 2.1 switching on and off Source components and power supplies for cd players, tuners, preamplifiers and crossovers should be switched on before switching on the amplifier(s). Always switch the amplifier(s) off and wait about a minute for its power supply capacitors to discharge before connecting or disconnecting any leads. Always use the power switch on the product rather than a mains outlet switch. 2.
3.0 Warnings Naim equipment is designed to offer the finest sound quality that can be achieved, avoiding compromise wherever possible. This can lead to circumstances that may be unfamiliar. The material that follows contains advice specifically related to Naim equipment as well as more general warnings about the use of domestic audio products. Please read it carefully.
4.0 Connection 4.1 mains lead As the colours of the wires in the mains lead of this apparatus may not correspond with the coloured markings identifying the terminals in your plug proceed as follows: The wire which is coloured GREEN-AND-YELLOW must be connected to the terminal in the plug which is marked by the letter E or by the safety earth symbol or coloured green or green-and-yellow.
nat 01 and nat 02 operation connections The FM aerial input socket must be connected via 75ohm low-loss coaxial cable to a suitable roofmounted directional aerial. aerial requirements The tuner aerial should be mounted on the roof, clear of obstructions and also as high as possible. Horizontally polarised aerials will respond to all UK broadcasts whilst partially rejecting police and taxi transmissions, and are therefore recommended.
nat 01 front signal stereo nat 01 rear connected to napst power supply nat 01 output nc nc ch1 ch 2 to preamplifier -ve 75 ohm FM aerial napst power supply mains input cable direction marker 6 Interconnect Cables 5 pin DIN 5 pin DIN (snaic)
nat 02 front signal stereo nat 02 rear power switch nat 02 output ch1 ch 2 nc nc -ve mains lead to preamplifier 75 ohm FM aerial Specifications nat 01 and nat 02 Tuning Range Output Level 01 02 Mains Supply CaseSize (H x W x D) VHF/FM 87.
nat 05 operation connections The FM aerial input socket must be connected via 75ohm low-loss coaxial cable to a suitable roofmounted directional aerial. aerial requirements The tuner aerial should be mounted on the roof, clear of obstructions and also as high as possible. Horizontally polarised aerials will respond to all UK broadcasts whilst partially rejecting police and taxi transmissions, and are therefore recommended.
nat 05 front down up mode mono • stereo • freq • scan • preset nat 05 rear RC5 input power 75 ohm FM aerial mains input to preamplifier note nat 05 output The RC5 input is designed to accept external control signals for multi-room applications. Contact your dealer for further information on its use. The nat 05 features various technologies to reduce microphonic effects, in particular a compliant mounting for the main circuit boards and the din sockets on the rear.
n2 narcom 2 remote handset NARCOM 2 is a multi-functional remote control handset designed to be used with Naim Audio CD players, integrated amplifiers, pre-amplifiers and preset tuners. The handset control configuration is based around three types of keys: System Component Keys, Global Keys and Soft Keys. 1 System Component Keys These keys switch the operation of the “Soft Keys” into modes appropriate to each system component (preamp, CD or tuner).
3 Soft Keys These keys operate functions depending on the System Component Key setting. numeric keypad: In preamp mode the numeric keys will switch between the amplifier inputs (1 - cd, 2 - tuner, 3 - tape, 4 - av, 5 - aux 1, 6 - aux 2). In cd mode the numeric keys will select tracks. In tuner mode the numeric keys will select tuner presets or can be used directly to input station frequencies. prog: In preamp mode the prog key function varies depending upon the specific amplifier model in use.
EC Declaration of Conformity to Appropriate Standards Manufacturer Naim Audio Limited Southampton Road Salisbury England SP1 2LN Products nat 01, nat 02, nat 05 tuners napst power supply Safety HD 195-S6 EN 60 065 EMC Emissions Tested to EN 55013 Sound and television broadcast receivers and associated equiment Immunity Tested to EN55020 Electromagnetic immunity of broadcast receivers and associated equipment In accordance with CISPR 16-1 Radio disturbance and immunity measuring apparatus CISPR 16-2 Metho
