O W N E R S M A N U A L Stageline Phono Stage
page 2 3 4 5 7 9 12 1.0 Equipment Installation 1.1 cables and connections 2.0 Getting Started 2.1 switching on and off 2.2 running in 2.3 mains supply 2.4 siting the equipment 2.5 if you have a problem 3.0 Warnings 4.0 Connection 4.1 mains lead 4.2 non-rewireable mains plugs 4.3 fuse carrier 4.
1.0 Equipment installation Normally your Naim equipment will have been installed by the dealer who sold it to you even if you live outside their immediate vicinity. Your dealer is responsible for making sure that the system sounds exactly as it should and information given here is not intended to reduce this responsibility in any way. 1.1 cables and connections Please do not modify the standard interconnect cables supplied with your Naim equipment. This is important for safety as well as performance.
2.0 Getting Started 2.1 switching on and off Source components and power supplies for cd players, tuners, preamplifiers and crossovers should be switched on before switching on the amplifier(s). Always switch the amplifier(s) off and wait about a minute for its power supply capacitors to discharge before connecting or disconnecting any leads. Always use the power switch on the product rather than a mains outlet switch. 2.
2.4 siting the equipment Power supplies and amplifiers should be located a reasonable distance away from other equipment. This separation will stop transformer radiation causing hum audible from the loudspeakers. The minimum recommended distance is 300mm (12 inches), and that allowed by the standard interconnect lead is the maximum. Some Naim equipment is extremely heavy. Ensure than your equipment rack or table can easily support the weight and is stable. 2.
3.0 Warnings Naim equipment is designed to offer the finest sound quality that can be achieved, avoiding compromise wherever possible. This can lead to circumstances that may be unfamiliar. The material that follows contains advice specifically related to Naim equipment as well as more general warnings about the use of domestic audio products. Please read it carefully.
important In order to comply with current European safety regulations it is essential that the Naim loudspeaker connectors supplied with amplifiers and loudspeakers are used. Do not under any circumstances allow anyone to modify your Naim equipment without first checking with the factory, your dealer, or your distributor. Unauthorised modifications will invalidate your guarantee. For your own safety do not under any circumstances open Naim equipment without first disconnecting the mains.
4.0 Connection 4.1 mains lead As the colours of the wires in the mains lead of this apparatus may not correspond with the coloured markings identifying the terminals in your plug proceed as follows: The wire which is coloured GREEN-AND-YELLOW must be connected to the terminal in the plug which is marked by the letter E or by the safety earth symbol or coloured green or green-and-yellow.
note This equipment has been tested and found to comply with the relevant EMC and Safety Standards, and, where applicable, also complies with the limits for a class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
Stageline Phono Stage Stageline is a separate phono stage suitable for one type of cartridge, either moving magnet or moving coil. Please confirm the type required with your dealer at time of purchase. Stageline can be powered either by a separate flatcap or Hi-cap, or from the dedicated supply built-in to the NAIT5 or NAC52 preamp. Power indicator Please see the diagrams for connection options.
Stageline connected to nait 5 output ch1 left ch2 right ground +Vin +Vin ch 2 ch1 output -ve cable direction marker input + power 10 - - signal out A signal out B AUX 2 AUX 1 A/V tape tuner cd + to left loudspeaker ch1 to right loudspeaker mains input ch2 Interconnect Cables link plugs fitted 5 to5 pin DIN
Stageline connected to nait 5 with power supply ch1 left ch2 right ground output Interconnect Cables 4 to 4 pin DIN 5 to5 pin DIN 4 to5 pin DIN to right loudspeaker ch2 to left loudspeaker ch1 link plug fitted input + - - signal out A signal out B AUX 2 AUX 1 A/V tape tuner cd + flatcap 2 power supply signal out A power out A power mains input signal out B signal out C signal out D 11
EC Declaration of Conformity to Appropriate Standards Manufacturer Naim Audio Limited Southampton Road Salisbury England SP1 2LN Products Stageline, nait 5, flatcap 2 power supply Immunity Tested to EN55020 Electromagnetic immunity of broadcast receivers and associated equipment In accordance with CISPR 16-1 Radio disturbance and immunity measuring apparatus CISPR 16-2 Methods of measurement of disturbances and immunity IEC 801-2 8KV (air gap) 4KV (contact) (performance criterion B) IEC 801-3 3V/m 20dB (
OWNSL Naim Audio Southampton Road Salisbury England SP1 2LN Tel: +44 (0)1722 332266 www.naim-audio.