User Guide

7
nac 52 connection to supercap power supply
bnc plug assembly
to nap 135, & 500
power amplifiers
to nap 140, 150, 180 &
250 power amplifiers
mains input
cable
direction
marker
4 to 4 pin DIN
5 to 5 pin DIN
Burndy
Interconnect Cables
bnc plugs are employed for phono inputs on the nac 52, 82 and 102. To wire a bnc
plug proceed as follows in conjunction with the illustrations opposite:
Place the clamp nut and plain gasket over the cable and cut back the cable outer
sheath 9mm.
Comb out the copper braid and insert the ferrule,
Trim the core insulation to 4mm and apply a thin layer of solder to the cable centre
conductor.
Mount the rear insulator over the core insulation and solder the male contact to the
core conductor.
Slide the clamp nut and plain gasket up to the ferrule and fit the front insulator
onto the male contact.
Slide the plug body over the assembly and tighten using the clamp nut.
plug body
trim braid to here
solder to cable before final asssembly
0.5mm
4mm
front
insulator
male
contact
rear
insulator
plain
gasket
ferrule
clamp
nut