User Manual

DIGITAL HT

11. Windscreen 12. Battery Good/Low LED Indicator

13. Power On/Off 14. Battery Cover

15. Battery Compartment / 2 AA Batteries LT

DIGITAL HT

HANDHELD MICROPHONE TRANSMITTER

HANDHELD OPERATION

1. Unscrew the BATTERY COMPARTMENT COVER (14) and insert 2 fresh AA

ALKALINE BATTERIES into the BATTERY COMPARTMENT(15), observing the

correct polarity as marked. Screw the cover back on to the microphone. Fresh alkaline

batteries can last up to 11 hours in use, but in order to ensure optimum performance,

it is recommended that you replace the batteries after every 8-10 hours of use.

2. Turn on the DIGITAL HT™ by sliding the POWER SWITCH (13) to turn on the

TX rst. The RF LED (3) on the DW-11/DW-22 receivers should now be lit, indicating

a received signal from the transmitter. The BATTERY INDICATOR LED (12) will

give a single quick ash, indicating usable battery strength. In the case of a dead or

low battery, it will either not go on at all or will stay on continuously, indicating that

the batteries should be replaced with fresh ones. To preserve battery life, turn the

transmitter off when not in use.

3. The microphone is now ready to use. Adjust the volume of the receiver per the

Audio Output Microphone Connection section above.

[Note: Observe care in selecting P.A. volume, transmitter location and speaker place-

ment so that acoustic feedback (howling or screeching) is avoided.]