User Manual
Table Of Contents
- 1、Connect scanner
- 1.1 Enable/Disable Parameter Bar Code Scanning
- 1.2 Restore Factory Defaults
- 1.3 User Defaults
- 1.4 USB Keyboard Setting
- 1.5 USB keyboard update speed setting
- 1.6 USB Keyboard Text-Transform
- 1.7 Keyboard Layouts
- 1.8 Virtual Keyboard Settings
- 1.9 Operation System Choice Under Virtual Keyboard
- 1.10 UNICODE output
- 2.1 Serial port setting
- 2.2 GS Control character replacement
- 2.3 Control character output
- 3、Scan mode
- 4、LED notifications
- 5、Beeper
- 6、Prefix and Suffix
- 7、Data editing
- 8、Symbologies
- 9、128码
- 9.1 Code 128
- 9.2 ISBT-128
- 9.3 GS1-128
- 9.4 Code 128 length limitation
- 9.5 UPC-A
- 9.8 UPC-E
- 9.11 EAN/JAN-8
- 9.13 EAN/JAN-13
- 9.14 UPC/EAN/JAN extra code
- 9.15 EAN13 to ISBN
- 9.16 EAN13 to ISSN
- 9.17 GS1 DataBar（RSS14）
- 9.18 GS1 DataBar Limited
- 9.19 GS1 DataBar Expanded
- 9.20 MSI
- 9.25 Febraban
- 9.28 PDF417
- 9.29 Micro PDF417
- 9.30 QR Code
- 9.31 Micro QR
- 9.32 Data Matrix
- 9.33 Aztec Code
- APPENDIX
- Configuration Instruction And Example
6
1、Connect scanner
Connect the barcode scanner to the special connector on the attached cable,
and plug the other end into the corresponding port of PC.
If the configuration code has been turned off, please refer to 1.1 to Enable
Parameter Bar Code Scanning.
1.1 Enable/Disable Parameter Bar Code Scanning
When the configuration code is turn on, All configuration codes available;
When the configuration code is turn off, you need setting it.
Enable Parameter Bar Code Scanning (Default)
Disable Parameter Bar Code Scanning
Firmware Version
1.2 Restore Factory Defaults
Restore Factory Defaults