User Manual

62
26
1A
SUB
27
1B
ESC
28
1C
FS
29
1D
GS
30
1E
RS
31
1F
US
Configuration Instruction And Example
Example for user-defined prefix and suffix:
You can edit 10 characters as prefix or suffix. (In order to make sure the prefix and suffix can output
normally, please enable user-defined prefix or suffix first)
Example 1.1
：
Add XYZ to all type of barcode as prefix.
Look up appendix 2, you can find that the HEX value for all codes is “99”. Look up appendix 3, the
HEX value for XYZ is “58,59,5A”. First scan “user-defined prefix” in 2.11 edit, then the scanner will
have two sounds like “D…D…”, then scan 9
，
9
，
5
，
8
，
5
，
9
，
5
，
A
，
and save, the setting accomplished.
If you want to change the prefix or suffix you set before you save the setting, you can scan “cancel
the data read last time” or “Cancel all data read before” to reset. If you want to give up setting scan
“Cancel current setting”.
Example 1.2
：
Add Q to QR code as prefix.
Look up appendix 2, you can find that the HEX value for QR code is “73”. Look up appendix 3, the
HEX value for Q is “51”. First scan “user-defined prefix” in 2.11 edit, then the scanner will have two
sounds like “D…D…”, then scan 7
，
3
，
5
，
1
，
and save, the setting accomplished.