User Manual
Table Of Contents
- 1、Connect scanner
- 1.1 Enable/Disable Parameter Bar Code Scanning
- 1.2 Restore Factory Defaults
- 1.3 User Defaults
- 1.4 USB Keyboard Setting
- 1.5 USB keyboard update speed setting
- 1.6 USB Keyboard Text-Transform
- 1.7 Keyboard Layouts
- 1.8 Virtual Keyboard Settings
- 1.9 Operation System Choice Under Virtual Keyboard
- 1.10 UNICODE output
- 2.1 Serial port setting
- 2.2 GS Control character replacement
- 2.3 Control character output
- 3、Scan mode
- 4、LED notifications
- 5、Beeper
- 6、Prefix and Suffix
- 7、Data editing
- 8、Symbologies
- 9、128码
- 9.1 Code 128
- 9.2 ISBT-128
- 9.3 GS1-128
- 9.4 Code 128 length limitation
- 9.5 UPC-A
- 9.8 UPC-E
- 9.11 EAN/JAN-8
- 9.13 EAN/JAN-13
- 9.14 UPC/EAN/JAN extra code
- 9.15 EAN13 to ISBN
- 9.16 EAN13 to ISSN
- 9.17 GS1 DataBar（RSS14）
- 9.18 GS1 DataBar Limited
- 9.19 GS1 DataBar Expanded
- 9.20 MSI
- 9.25 Febraban
- 9.28 PDF417
- 9.29 Micro PDF417
- 9.30 QR Code
- 9.31 Micro QR
- 9.32 Data Matrix
- 9.33 Aztec Code
- APPENDIX
- Configuration Instruction And Example
29
Prefix+User-defined prefix+CODE ID+AIM ID
Suffix
User-defined suffix+CODE ID+AIM ID+suffix（default）
CODE ID+AIM ID+User-defined suffix+suffix
7、Data editing
The data editing function can customize the data field with complete barcode content to start
/ Center / end by configuring the length of start / end field. Please configure the length and
transmission of the start / end field according to the actual needs.
Note: non barcode contents such as suffix, start character, end character, code ID, aim ID
are not affected by data editing function.
7.1 Upload setting
Upload complete Data（default）
Upload Start data field