Installation Manual

- 5 -
Window material and color
The material and color of the window should be chosen in consideration of the illumination of the E3000H
and the wavelength of the light wave that the CIS can respond to (mainly red and white), so that the light
transmittance is as high as possible, while ensuring the lowest possible blur and uniform refractive index. .
PMMA or optical glass is usually used, and the window material has a red light transmittance of more than
90% and a haze of less than 1%. Whether or not the coating is applied to the window material depends on
the specific material and application.
Window scratch and coating
Scratch on the window will reduce the reading performance of the E3000H. It is recommended to consider
the window anti-scratch and anti-fouling design. Consider choosing a high-abrasion material or a wear-
resistant coating on the window material.
Aimbent Light
The E3000H can achieve better performance in the presence of ambient light, and can be well adapted to
the fluorescent flicker of 50~60Hz common lighting AC, but in high frequency pulse flash environment,
performance may be due to interference. reduce.
Safe Use
The E3000H uses light-emitting diodes (LEDs) to form the aiming indication pattern. The wavelength range
of the light wave generated by the LED under normal use is safe, but it should still avoid direct-viewing the
LED or directing the beam to the human eye during use to avoid causing Discomfort.
Mounting
When integrating the E3000H, refer to the following physical size specifications. Structural design Note that
other components cannot oppress the E3000H device.
E3000H Low view（：mm）