Installation Manual

- 3 -
Chapter 1 Introduction
General Requiremetns
ESD
The E3000H has been designed to protect against static electricity and uses anti-static packaging. However,
anti-static measures should be taken during unpacking and use, such as grounding wrist straps and
grounding of the work area.
Dustproof
The E3000H must be sufficiently sealed during storage and use to prevent dust, particles or other
contaminants from adhering to the lens, circuit board, etc. Dust particles or contaminants can degrade
engine performance and even affect engine usage.
Envoirnmental
The normal use of the E3000H is subject to the following environmental requirements.
Operatin Temperature
-20℃ ~ 55℃
Storage Temperature
-20℃ ~ 60℃
Humidity
5% ~95%
Thermal considerations
The E3000H emits heat during operation. In the case of continuous operation at full speed for a long time,
the heat will accumulate to increase the temperature of the CIS chip and the decoder chip. Although the
E3000H can be adapted to work in high temperature environments, in high temperature environments, the
image noise of the CIS is increased to degrade the image quality, and the reading performance may be
degraded. When considering the application of the E3000H in a high-temperature environment, it is
recommended to test whether the possible read performance degradation is within an acceptable range,
and then determine whether to perform proper heat dissipation design.
At the time of design, the E3000H is reserved for space that can form natural convection or forced
convection.
Avoid wrapping the E3000H with insulation such as rubber.