Manualshelf

Installation Manual

ManualsBrandsNADAMOO ManualsBar Code ScannersBarcode Scanner Module EP2600, Embedded 1D 2D QR Auto-scan Barcord Reader CMOS Support Screen Scan USB (SDK & Serial Command Available for Development) Fixed Mount to Self-Service Equipment
12345678910
- 12 -
Connector
The figure below is a schematic of the E3000H connector. It uses a ZIF 12 PIN lower contact socket and is
connected to the peripheral (host) with a flexible cable. The lower icon shows the size of the socket (unit:
mm).
Flat Cable
The 12PIN flexible cable used in the E3000H connector can be designed as the same or different-sided
cable according to the application. The specifications must meet the following requirements. To ensure the
reliability and stability of the connection, use a reinforcing material at the connection end of the cable and
reduce the impedance on the wire.