Manualshelf

Installation Manual

ManualsBrandsNADAMOO ManualsBar Code ScannersBarcode Scanner Module EP2600, Embedded 1D 2D QR Auto-scan Barcord Reader CMOS Support Screen Scan USB (SDK & Serial Command Available for Development) Fixed Mount to Self-Service Equipment
12345678910
Chapter 3 Electrical characteristics
6
operation to achieve the lowest consumption.
E4000 is less than 4s from power on to completion. After turning off the power, it is recommended to allow the power input
to be turned on again after more than 500ms.
Ripple noise
Since the power input of the E4000 is directly supplied to the image sensor and the decoder chip, a low ripple noise
power input is required to ensure stable operation. It is recommended to control the ripple noise to within 50mV (peak-to-
peak), at least not to exceed 100mV.(peak-to-peak).