Installation Manual

Chapter 3 Electrical characteristics
3
Window material and color
The material and color of the window should be chosen in consideration of the illumination of the E4000 and the
wavelength of the light wave that the CIS can respond to (mainly red and white), so that the light transmittance is as high as
possible, while ensuring the lowest possible blur and uniform refractive index. . PMMA or optical glass is usually used, and
the window material has a red light transmittance of more than 90% and a haze of less than 1%. Whether or not the coating
is applied to the window material depends on the specific material and application.
Window scratch and coating
Scratch on the window will reduce the reading performance of the E4000. It is recommended to consider the window
anti-scratch and anti-fouling design. Consider choosing a high-abrasion material or a wear-resistant coating on the window
material.
Aimbent Light
The E4000 can achieve better performance in the presence of ambient light, and can be well adapted to the fluorescent
flicker of 50~60Hz common lighting AC, but in high frequency pulse flash environment, performance may be due to
interference. reduce.
Safe Use
The E4000 uses light-emitting diodes (LEDs) to form the aiming indication pattern. The wavelength range of the light
wave generated by the LED under normal use is safe, but it should still avoid direct-viewing the LED or directing the beam
to the human eye during use to avoid causing Discomfort.
Mounting
When integrating the E4000, refer to the following physical size specifications. Structural design Note that other
components cannot oppress the E4000 device.