Installation Manual

Chapter 3 Electrical characteristics
1
Chapter 1 Introduction
General Requiremetns
ESD
The E4000 has been designed to protect against static electricity and uses anti-static packaging. However, anti-static
measures should be taken during unpacking and use, such as grounding wrist straps and grounding of the work area.
Dustproof
The E4000 must be sufficiently sealed during storage and use to prevent dust, particles or other contaminants from
adhering to the lens, circuit board, etc. Dust particles or contaminants can degrade engine performance and even affect
engine usage.
Envoirnmental
The normal use of the E4000 is subject to the following environmental requirements.
Operatin Temperature
-20℃ ~ 55℃
Storage Temperature
-20℃ ~ 60℃
Humidity
5% ~95%
Thermal considerations
The E4000 emits heat during operation. In the case of continuous operation at full speed for a long time, the heat will
accumulate to increase the temperature of the CIS chip and the decoder chip. Although the E4000 can be adapted to work
in high temperature environments, in high temperature environments, the image noise of the CIS is increased to degrade the
image quality, and the reading performance may be degraded. When considering the application of the E4000 in a high-
temperature environment, it is recommended to test whether the possible read performance degradation is within an
acceptable range, and then determine whether to perform proper heat dissipation design.
At the time of design, the E4000 is reserved for space that can form natural convection or forced convection.
Avoid wrapping the E4000 with insulation such as rubber.