Quick Setup Guide
©2020 NAD ELECTRONICS INTERNATIONAL, A DIVISION OF LENBROOK INDUSTRIES LIMITED
All rights reserved. NAD and the NAD logo are trademarks of NAD Electronics International, a division of Lenbrook Industries Limited.
No part of this publication may be reproduced, stored or transmitted in any form without the written permission of NAD Electronics International.
CI8-150DSP-QS-EN-v06 - 01/20
4.
3.
© NAD CI 8-150 DSP
© NAD CI 8-150 DSP
© NAD CI 8-150 DSP
2.
x1/x2/x3/x4
+ -- +
STEREO
© NAD CI 8-150 DSP
© NAD CI 8-150 DSP
© NAD CI 8-150 DSP
© NAD CI 8-150 DSP
x1/x2/x3/x4
- +
BRIDGE
STANDBY AND CHANNEL LED STATUS INDICATORS
DESCRIPTION STANDBY LED STATUS CHANNEL LED 1-8 STATUS
Operating mode Blue If there is a signal, corresponding channel
LED is solid blue or no light if no signal.
Standby mode Amber O, no light
System reboot Flashing amber O, no light
Overvoltage or under voltage Red O, no light
AMP current error Blue Corresponding channel LED is red.
AMP DC error Red O, no light.
POWER CONSUMPTION AND HEAT OUTPUT
CONDITION
230V/50HZ 120V/60HZ
POWER
CONSUMPTION (W)
HEAT OUTPUT
(BTU/HR)
POWER
CONSUMPTION (W)
HEAT OUTPUT
(BTU/HR)
Eco mode Standby Power at 8 ohms 0.4 1.4 0.4 1.3
Network Standby Power at 8 ohms 1.2 4.2 1.2 4.1
Idle power at 8 ohms 86 295 88 299
Output power at 8
ohms, all channels
driven
1/8 rated power 243 826 246 836
1/3 rated power 529 1799 540 1836
1/2 rated power 758 2577 781 2655
Full rated power 1512 5140 1557 5294
Output power at 4
ohms, all channels
driven
1/8 rated power 251 853 255 867
1/3 rated power 552 1877 561 1907
1/2 rated power 790 2686 813 2764
Full rated power 1540 5236 1600 5440
IMPORTANT
Visit nadelectronics.com/product/ci-8-150-multi-channel-amplier or support.nadelectronics.com for further information and assistance.
1
2