Specification Sheet

NAD Electronics International reserves the right to change specifications or features without notice. NAD is a registered trademark of NAD Electronics International.
All rights reserved. No part of this publication may be reproduced, stored, or transmitted in any form whatsoever without the written permission of NAD Electronics
International. © 03/17 16-048 NAD Electronics International. www.NADelectronics.com
Specifications C 368
* Gross dimensions include feet, extended buttons and rear panel terminals. ** Non-metric measurements are approximate. NAD Electronics will not assume any liability for errors being made by retailers, custom
installers, cabinet makers, or other end users based on information contained in this document. Note: Installers should allow a minimum clearance of 55mm for wire/cable management.
PREAMPLIFIER
Line Input, Pre Out
THD (20Hz - 20kHz) <0.005% at 2V out
Signal/Noise Ratio >106dB (IHF; A-weighted, ref. 500mV out, unity gain)
Channel separation >80dB (1kHz); >70dB (10kHz)
Input Impedance (R and C) 22 kilohm + 100pF
Maximum input signal >4.5Vrms (ref. 0.1% THD)
Output impedance Source Z + 240 ohm
Input sensitivity 93mV (ref. 500mV out, Volume maximum)
Frequency response ±0.03dB (20Hz - 20kHz)
Maximum voltage output -IHF load >4.5V (ref. 0.1% THD)
Tone Controls Treble: ±7.0dB at 20kHz; Bass: ±7.0dB at 60Hz; Balance: -10dB
Phono Input, Pre Out
THD (20Hz - 20kHz) <0.01% at 2V out
Signal/Noise Ratio >84dB (200 ohm source; A-weighted, ref. 500mV out)
>76dB (MM cartridge source, IHF; A-weighted, ref. 500mV out)
Input sensitivity 1.44mV (ref. 500mV out, Volume maximum)
Frequency response ±0.3dB (20Hz - 20kHz)
Maximum input signal at 1kHz >80mVrms (ref. 0.1% THD)
Line Input, Headphone Out
THD (20Hz - 20kHz) <0.005% at 1V out
Signal/Noise Ratio >110dB (32 ohm loads; A-weighted, ref. 2V out, unity gain)
Frequency response ±0.3dB (20Hz - 20kHz)
Channel separation >60dB at 1kHz
Output impedance 6 ohm
GENERAL SPECIFICATIONS
Line In, Speaker Out
Continuous Output Power into 4 ohms and 8 ohms (Stereo) >80W (at rated THD, 20Hz - 20kHz, both channels driven)
Continuous Output Power into and 8 ohms (Bridge mode) 300W (ref. 20Hz - 20kHz at THD 0.03%)
IHF Dynamic Power 2 ohm 250W
4 ohm 200W
8 ohm 120W
IHF Dynamic Power (Bridge mode) 4 ohm 560W
8 ohm 500W
THD (20Hz - 20kHz) <0.03% (250mW to 80W, 8 ohm and 4 ohm)
Signal/Noise Ratio >98dB (A-weighted, 500mV input, ref. 1W out in 8 ohm)
Clipping power >95W (at 1kHz 0.1% THD)
Clipping power (Bridge mode) >315W (at 1kHz 0.1% THD)
Peak output current >20A (in 1 ohm, 1ms)
Damping factor >300 (ref. 8 ohm, 20Hz to 6.5kHz)
Frequency response ±0.3dB (20Hz - 20kHz)
Channel separation >75dB (1kHz); >70dB (10kHz)
Input sensitivity (for 80W in 8 ohm) Line In: 470mV; Digital In: 21% FS
Supports bit rate/sample rate Up to 24bit/192kHz
Standby Power <0.5W
Frequency Band 2.402G - 2.480G
Maximum transmit power (dBm) 7dBm ± 2dBm
DIMENSIONS AND WEIGHT
Dimensions (W x H x D) 435 x 100 x 390mm (17 1/8 x 3 15/16 x 15 3/8)”
Net Weight 7.8kg (17.2lb)
Shipping Weight 10.1kg (22.3lb)