Owner's Manual
Table Of Contents
- IMPORTANT SAFETY INSTRUCTIONS
- INTRODUCTION
- IDENTIFICATION OF CONTROLS
- OPERATION
- USING THE T 748 - MAIN MENU
- USING THE T 748 – SETUP MENU
- SETUP MENU
- SOURCE SETUP
- Source Setup (Normal)
- Source Setup (Table)
- iPod SETUP
- Speaker Setup
- AUTO CALIBRATION
- Speaker Configuration
- Speaker Levels
- Speaker Distance
- Adjusting the Volume
- Amplifier Setup
- HDMI setup
- Listening Mode Setup
- Listening Modes
- DOLBY DIGITAL SURROUND MODES
- Dolby Setup
- DTS Setup
- DTS SURROUND MODES
- ENHANCED STEREO
- Display Setup
- A/V Presets SETUP
- AUTO POWER DOWN SETUP
- LISTENING TO AM/FM RADIO
- LISTENING TO DAB RADIO
- OPERATION
- REFERENCE
8 SOURCE [ 3/4 ]
• Toggle through the input selections - Source 1, Source 2, Source 3,
Source 4, iPod, Source 7, Front Input, Media Player and Tuner (AM/
FM/DAB as applicable). More Sources can be directly recalled upon
enabling them at the Setup Menu.
• Refer also to the item about SOURCE SETUP under the USING THE
T 748 - SETUP MENU segment of the OPERATION section.
9 VOLUME
• The VOLUME control adjusts the overall loudness of the signal being
fed to the loudspeakers or headphones.
• Turn clockwise to increase the volume level; counter clockwise to
lower it.
10 PHONES
• Accepts stereo headphone using a standard 1/4-inch stereo phone
plug (use a suitable adaptor for headphones equipped with a
smaller plug).
• Plugging in headphones automatically mutes output from the
speakers.
• For headphone listening, the Front speakers must be set to “Large” at
the “Speaker Conguration” of the Speaker Setup item at the Setup
Menu; otherwise headphone bass response will be restricted.
• Plugging in headphones will automatically switch the T 748 to
Stereo or Analog Bypass modes.
11 FRONT INPUT PORTS
• Use these convenience jacks for occasional sources such as a
camcorder, video game console, any analog audio or optical digital
audio sources and composite video sources.
• If your source has two output jacks indicative of stereo output,
insert both jacks into the T 748’s corresponding Front “L” (item A) and
“R (MONO)” input to achieve stereo output as well.
• On the other hand, if your source has a single audio out jack only or
is marked “Mono output”, plug this into the T 748’s Front “R (MONO)”
input (item B).
• Connect composite video output source to the front composite
video input (item C).
• Connect S-Video output source to the front S-Video input (item D).
• Use the front optical audio input (item E) for optical digital audio
sources.
12 FRONT MP/MIC INPUT
• Connect your Media Player’s standard stereo phone jack to this
input.
• This is also same input where the supplied microphone is
connected for speaker auto calibration.
• Refer also to the item about AUTO CALIBRATION under the USING
THE T 748 - SETUP MENU segment of the OPERATION section.
IDENTIFICATION OF CONTROLS
FRONT PANEL
7
ENGLISHPORTUGUÊS FRANÇAISESPAÑOLITALIANODEUTSCHNEDERLANDSSVENSKAРУССКИЙ