Owner's Manual
Table Of Contents
- IMPORTANT SAFETY INSTRUCTIONS
- INTRODUCTION
- IDENTIFICATION OF CONTROLS
- OPERATION
- USING THE T 748 - MAIN MENU
- USING THE T 748 – SETUP MENU
- SETUP MENU
- SOURCE SETUP
- Source Setup (Normal)
- Source Setup (Table)
- iPod SETUP
- Speaker Setup
- AUTO CALIBRATION
- Speaker Configuration
- Speaker Levels
- Speaker Distance
- Adjusting the Volume
- Amplifier Setup
- HDMI setup
- Listening Mode Setup
- Listening Modes
- DOLBY DIGITAL SURROUND MODES
- Dolby Setup
- DTS Setup
- DTS SURROUND MODES
- ENHANCED STEREO
- Display Setup
- A/V Presets SETUP
- AUTO POWER DOWN SETUP
- LISTENING TO AM/FM RADIO
- LISTENING TO DAB RADIO
- OPERATION
- REFERENCE
7 You can setup up to 5 A/V Presets. These same A/V Presets can also be
associated/defaulted to each Source in the “Source Setup (Normal)”
window as below.
In the above example, “Preset 1” settings are allocated to Source 1.
Whenever Source 1 is accessed, the “Preset 1” settings will be applied to
Source 1.
AUTO POWER DOWN SETUP
The T 748 can be setup to automatically go to standby mode if there is
no user interface interaction within the allocated time. Set “Auto Timer” to
preferred time.
4hrs, 8hrs, 30mins: Set time to allow the T 748 go to standby mode
automatically in the absence of any user interface interaction.
O: The T 748 remains active even though no user interface interaction
is detected.
OPERATION
USING THE T 748 SETUP MENU
28
ENGLISH PORTUGUÊSFRANÇAIS ESPAÑOL ITALIANO DEUTSCH NEDERLANDS SVENSKA РУССКИЙ