Owner's Manual

While at “Save Settings to Setup” menu line, use [ S ] to save the above
settings to Preset 1. Below OSD will be shown, arming that the above
settings are now saved to “Preset 1”.
When associated to a particular Source number, the above preset values
and settings allocated at “Preset 1” (preset settings as shown in the OSD
captures at Step 1) will be recalled and applied to said assigned source.
4 Now, repeat again Step 1 above but this time with the following
settings
Listening Mode: PLIIx Music
DSP Options: 0ms
Tone Controls: Tone Defeat: O
Display Setup: Set “Line 2” to “Volume”
5 With the above settings, scroll to “A/V Presets Setup” from the SETUP
MENU page. Use [ S ] to access “A/V Presets Setup” menu.
6 At “A/V Presets Setup” page, set “Preset: 2” to the following conditions as
below. Use [ D/F ] to select “Yes” or “No”. Then, press [ A ],  F  and [ S ]
to exit a line item and move on to the next setting.
While at “Save Settings to Setup” menu line, use [ S ] to save the settings
above to “Preset 2”. When associated to a particular Source number, the
above preset values and settings allocated at “Preset 2” (preset settings
as shown in the OSD captures at Step 4) will be recalled and applied to
said assigned source.
Note that “Speaker Setup” is set to “No”. At this condition, there will be
no “Speaker Setup” settings that will be associated to “Preset 2”. The
“Speaker Setup” settings that will be applied to “Preset 2” will be the last
or current “Speaker Setup” settings which in this sample are the same
“Speaker Setup” settings shown above in Step 1.
OPERATION
USING THE T 748  SETUP MENU
27
ENGLISHPORTUGUÊS FRANÇAISESPAÑOLITALIANODEUTSCHNEDERLANDSSVENSKAРУССКИЙ