Owner's Manual
Table Of Contents
- IMPORTANT SAFETY INSTRUCTIONS
- INTRODUCTION
- IDENTIFICATION OF CONTROLS
- OPERATION
- USING THE T 748 - MAIN MENU
- USING THE T 748 – SETUP MENU
- SETUP MENU
- SOURCE SETUP
- Source Setup (Normal)
- Source Setup (Table)
- iPod SETUP
- Speaker Setup
- AUTO CALIBRATION
- Speaker Configuration
- Speaker Levels
- Speaker Distance
- Adjusting the Volume
- Amplifier Setup
- HDMI setup
- Listening Mode Setup
- Listening Modes
- DOLBY DIGITAL SURROUND MODES
- Dolby Setup
- DTS Setup
- DTS SURROUND MODES
- ENHANCED STEREO
- Display Setup
- A/V Presets SETUP
- AUTO POWER DOWN SETUP
- LISTENING TO AM/FM RADIO
- LISTENING TO DAB RADIO
- OPERATION
- REFERENCE
SAMPLE PROCEDURE FOR SETTING UP A/V PRESETS
1 Setup rst your preferred settings for the following options (access
them through their respective menu page).
Listening Mode: Stereo
DSP Option: 5ms
Tone Controls: Tone Defeat: On
Display Setup: Set “Line 2” to “Listening Mode”
Speaker Setup: from the Speaker Setup menu, go to “Speaker
Conguration” sub-menu and change “Subwoofer” from “On” to “O”:
“Front” becomes “Large”
2 With the above settings, scroll to “A/V Presets Setup” from the SETUP
MENU page. Use [ S ] to access “A/V Presets Setup” menu.
3 At “A/V Presets” page, set “Preset: 1” to the following conditions as below.
Use [ D/F ] to select “Yes” or “No”. Then, press [ A ], [ F ] and [ S ] to exit a
line item and move on to the next setting.
OPERATION
USING THE T 748 SETUP MENU
26
ENGLISH PORTUGUÊSFRANÇAIS ESPAÑOL ITALIANO DEUTSCH NEDERLANDS SVENSKA РУССКИЙ