Users Manual

EN /
I FCC statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause
undesired operation.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Statement for Class B digital device as below
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocated the receiving antenna.
- Increase the separation between the equipment and dongle.
- Connect the equipment into an outlet on a circuit different from that to which
the dongle is connected.
- Consult the dealer or an experienced radio / TV technician for help.
This equipment complies with FCC’s RF radiation exposure limits set forth for
an uncontrolled environment. The antenna(s) used for this transmitter must
be installed and operated to provide a separation distance of at least 20 cm
from all persons and must not be collocated or operating in conjunction with
any other antenna or transmitter. Installers must ensure that 20cm separation
distance will be maintained between the device (excluding its handset) and
users.