E700 WIDE AREA VACUUM
Congratulations on your purchase of a Wide Area Vacuum This machine has been manufactured in the EC under the most stringent manufacturing and quality standards. These Operating Instructions contain all the necessary information related to the operation and maintenance of the machine. Read these Operating Instructions carefully before you start using the machine or carrying out any maintenance activities. You will find that this machine will more than fulfil your needs.
Wide Area Vacuum To reduce risk of fire, electric shock, or injury: Do not pick up anything that is burning or smoking, such as cigarettes, matches or hot ashes. Do not use without dust bag in place. Use extra care when cleaning on stairs. Do not use to pick up flammable or combustible liquids such as gasoline, or use in areas where they may be present. Do not use outdoors or on wet surfaces. Do not leave vacuum cleaner unattended when plugged in.
Wide Area Vacuum Removing the machine from the cardbox 1 - Open the cardbox - Take out the tooling and other loose items 2 - Tip the box over so that the machine stands on its rear side - Roll out the machine 1 Installation 34 - Pull the push handle backwards into operating position.
Wide Area Vacuum Checks and Operation Check if all the tooling is present and put everything in position as shown.
Wide Area Vacuum Operation When all the tooling of the vacuum cleaner is installed, the connect the power cord to a wall outlet. On the display the green power supply indicator (1) will light up. If this does not happen, check the power cord or change the main power cord. By turning on the main switch A, the vacuum motors are activated with a time delay. The brush will operate by pushing handle B. The brush sensor system will indicate the status of the brush pressure on the display.
Wide Area Vacuum Control panel The machine has a unique motor control system to help you as an operator and to help services and repairs. 1 2 The control panel. 1. Power Supply Indicator 2. Infra-red port with a special terminal to read information. Number of hours in operation. Number of times activated. Number of times overheated because of blockages. Reset or reprogram the zones green, yellow and red. The three indicators on the panel 3. Green Brush pressure okay Height is ok 4.
Wide Area Vacuum OPTION Placing the dust bag into the SMS bag Unplug the machine from the wall outlet before changing the dustbag.
Wide Area Vacuum Placing the dust bag 9 10 8
