USE AND MAINTENANCE INSTRUCTIONS FOR THE SELF-CONTAINED CLEANING MACHINE AVB4X READ THESE INSTRUCTIONS CAREFULLY BEFORE USING THE MACHINE 1205 Britannia Road East Mississauga, Ontario, Canada L4W IC7 Tel: 905 795 0122 Toll Free: 1 800 387 3210 Fax: 1 800 709 2896
Generalities The body of the carpet cleaning machine Sharon-Brush is composed by two high-density polyethylene tanks, kept together with elastic hooks. The upper tank is meant to contain the dirty water sucked from the carpet, while the lower tank is meant to contain clean water and detergent. The lower tank also contains the vacuum motor, the pump and the control panel. The vacuum head, the spray nozzle and the rotating brush are situated below the lower tank.
WARNING: Electrical Hazard. Before putting the machine’s plug in the current socket, check that the voltage available is the same indicated on the label of the machines. Be sure that the electrical system is well earthed and that it has a safety differential switch. Verify that the cable plug is complying with the outlet. Do not modify plug. Do not use adapters or multiple sockets, without knowing the electrical input of each user.
Preparation for Work The carpet cleaning machine Sharon-Brush is designed to clean large areas of carpet and hard floor, even without using external accessories, since the washing device is situated below the body of the machine (see paragraph Use as a Self-contained Machine). It is also possible to clean upholstery, inside of cars or hard-to-reach areas, by using additional accessories, which must be connected to the machine with connecting hoses (see paragraph Use with Accessories).
Use as a Self-contained Machine In this modality the machine washes and dries with the spray nozzle and the vacuum head which are situated below the body of the machine. To switch on the machine you must act on the switches on the control panel: 1. Set to position "I" the switch of the vacuum motor. 2. Set to position "I" the pump switch. In this way the solution pump works only while you rotate the hand grip of the machine. 3. To clean carpets, rotate the lever on the vacuum head towards the right side.
Use with Accessories In this modality the machine works as a classical extractor, for which you clean a surface by using accessories which are external to the machine body. After filling the tanks with solution and inserting the plug in the wall outlet (see the Paragraph Preparation for work), you need to perform the following operations: 1. Connect the machine to the wand or to the hand-tool using the solution and the vacuum hoses.
Maintenance The model Sharon-Brush is a professional machine. The warranty on these machine is of 1 year and regards the faults due to manufacturing defects. The faults due to improper use are not covered by warranty. For further details regarding warranty, contact the distributor supplying the machine. For a good preservation and a long duration of the machine, observe the following advice: 1. After every use, before storing the machine, remove all the water from the solution and the recovery tank.
