User's Manual

N-ear 20210908 V2.1 N-ear 20210908– V2.1
User’s Manual
Wireless PTT (IP67) works with Choice wireless capable PTTs
Model: CWPTT
Transmitter: DC 3V, 225mAh battery inside
Receiver: DC 5V, 20mA power supply from the radio
Choice Wireless Capable PTTs
Instructions:
1. Pull the battery plastic safety separator from the PTT.
2. Power OFF the radio.
3. Plug C+WPTT/C+WWPTT to the radio and then power ON the radio.
4. Simultaneously press and hold the PTT button on CWPTT and the Blue
button on rear side of C+WPTT/C+WWPTT for approx. 3 seconds to enter
pairing mode.
5. After successful pairing, the radio will be in TX mode, release both buttons.
6. Once successfully paired, press PTT on CWPTT once
to exit pairing mode.
7. Repeat the above steps to pair additional wireless PTT units with
C+WPTT/C+WWPTT.
ATTENTION
This device complies with part 15 of the FCC Rules and ISED Canada license-exempt
RSS standard(s). Operation is subject to the following 2 conditions: (1) This device
may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. The device can be used in portable exposure condition
without restriction.
C+WPTT
C+WWPTT

Summary of content (1 pages)