Instructions / Assembly

Shelves

Poles

Spacers

1.Before beginning assembly of product, make sure all parts are present. Compare parts with package contents

list and hardware contents . If any part is missing or damaged, do not attempt to assemble the product.

2.Estimated Assembly Time: Approximately 15 - 25 minutes.

3.Helpful Tools (not included):Rubber Mallet.

4.Decide on the shelf location before beginning the assembly.Once the Product is assembled,it is very difficult to

move a shelf without taking the entire assembly apart and starting over.

5.No Tools Required for Assembly.

Part Description Picture

CARE AND MAINTENANCE

NOTICE

- Two adults required for a assembly.

- Do not allow children to climb or play in or around the shelves.

- Assemble on a soft surface, such as carpeting to avoid scratching the finish.

PREPARATION

Never use abrasive or acid-based cleaners on the shelf rack.

Clean shelves and rods with a solution of mild detergent and water. Use a soft cloth or sponge to wipe

parts. Rinse and dry thoroughly. Keep surfaces dry and clean for a longer lasting finish.

Please read and understand these instructions before attempting to assemble, operate or install the product.

Reference Photo

WARNING

If the item is up to 59in high, this step isREQUIRED to ensure the stability of the item.

Using a pencil (not included) through the top shelf (A),

mark the screw hole locations, then set the item aside

(with the help of another person).

Using a 1/4-in. drill bit (not included), drill a 1/4-in. pilot

hole at marked locations. Insert anchors (BB) into the

holes, then move the item back into position. Insert the

screws (CC) through washers (AA) and the shelf (A),

then into the anchors (BB).

Hardware Used (not shown actual size)

Screw

x 2

Anchor

Washer

PAGE 1
CARE AND MAINTENANCE Never use abrasive or acid-based cleaners on the shelf rack. Clean shelves and rods with a solution of mild detergent and water. Use a soft cloth or sponge to wipe parts. Rinse and dry thoroughly. Keep surfaces dry and clean for a longer lasting finish. Part NOTICE Please read and understand these instructions before attempting to assemble, operate or install the product. - Two adults required for a assembly. - Do not allow children to climb or play in or around the shelves.
PAGE 2
A ssem b l y I n st r u ct i ons 2 B 3 C B A C C Corner hole top and bottom difference A B B Use a pen to mark the height on the 4 Poles (B) with levelers. Be sure all poles are marked in the same location. 4 A A B B Attach 2 Spacers (C) at the pen marks on the 4 Poles (B). Keep the arrows on the spacers (C) pointed upwards. 5 Place the Poles (B)with levelers through the corner holes of 1 Shelf (A).Fit the shelf carefully and securely over the Spacers (C).