User manual

8X96 ADC and DAC User Manual Page 32 of 54
for current literature, manuals and online email support check http://www.mytekdigital.com
Cloning enabled, (88/96k, MRX MODE2–96 =3x20@88/96):
Channels 1-3 are bit-split (MRX) . Channels 1-3 are output/input in MRX
pairs on connector A and B simultaneously. Channels 4-8 are not used.
Machine A/B select switch can select the source to be either connector A
or B.
Cloning enabled, (44/48k, MRX MODE1 =4x24@44/48):
Channels 1-4 are bit-split (MRX) . Channels 1-4 are output/input in MRX
pairs on connector A and B simultaneously. Channels 5-8 are not used.
Machine A/B select switch can select the source to be either connector A
or B.
Cloning enabled, (44/48k, MRX MODE2 =6x20@44/48):
Channels 1-6 are bit-split (MRX) . Channels 1-6 are output/input in MRX
pairs on connector A and B simultaneously. Channels 7-8 are not used.
Machine A/B select switch can select the source to be either connector A
or B.
AES is Dual Wire for 88/96 – In on position AES I/O operates in dual wire mode ie hi-
speed 96(88)k signal is split into two 48(44)k streams (similar to S/MUX- see further
description about S/MUX). In this mode each AESI/O carries single channel of audio (as
opposed to usual stereo). Only 4 channels (1-4) are available through AES I/O in this
mode.