User manual

Mytek Stereo 192-DSD Digital to Analog Converter – User Manual

Function Buttons

The two buttons, FN1 and FN2, are user programmable

switches. Each button's function is set by choosing it in the

menu. The following options are available (* PCM Only):

Input – Allows the user to select 3 user “presets,” Input A,

Input B, Input C; Each input can be assigned to either SPDIF,

AES, Toslink/ADAT, USB1, USB2, Firewire, Analog/SDIF or

none. The none allows to only switch between 2 Input

presets.

Mute – Mutes the audio.

Phase – Inverts the signals phase.

Mono *– Sums left and right to mono.

L-R *– Subtracts one channel from the other, canceling out

mono information while leaving the stereo information.

Mid Side *– A combination of Mono (L+R) and L-R, the

mid signal is the sum of L and R (mono) and the side signal

is the stereo information from the L-R operation.

Dim Vol – Instantly lowers the level by 20dB.

Display

There are several choices pertaining to the display.

Brightness – Of the LED display.

Meters – Turns the signal level meters on or off. (Available

on black panel versions only.)

Auto-Off – This will turn the display off after the selected

amount of time. A dim dot will stay lit to show that the unit

is operational.

Remote

Enable – On and Off. Allows the Stereo192-DSD DAC to be

controlled by a Remote Control

Mode - Select the remote type Apple or RC 5.

Firmware

Version – Displays the current Firmware version.

Restore - This will restore all of the unit's parameters to the

factory default.